After a snowfall, your solar app may show very low or no production. Before looking for a way to clear the panels, check what you can safely observe and what information will help your installer. For a rooftop system, access and the condition of the building come before recovering a few kilowatt-hours.
What may explain the drop in production
Snow covering the panels limits the light reaching the cells. The impact depends on local conditions and how long the panels remain covered. The Sandia National Laboratories research examines both production losses and mechanical stress caused by snow. Therefore, a general estimate for a different area is not enough to assess your own installation.
Record when the app was last updated, the daily production, and any error message. An outdated reading caused by a loss of communication requires different troubleshooting from an up-to-date reading showing low production. Save screenshots so the technician can see how things change when conditions improve.
Observe from a safe place on the ground
If you can see the panels from the ground, note whether they are fully or partially covered and whether snow has accumulated along the lower edge of the roof. Take zoomed-in photos from a spot outside the path where snow could fall. The IEA PVPS report on soiling losses points out that snow sliding suddenly off residential solar panels can create a hazard below the roof.
Keep people, pets, and vehicles away from the exposed area. If the area is a shared walkway, notify the property manager so safe access can be arranged. Do not climb a ladder, an icy terrace, or a roof to get a better photo.
Discuss whether work is needed before clearing the snow
The NREL operations and maintenance guide notes that snow removal is generally avoided because of the risk of damaging the frames, though in some cases it may be needed to address roof loads or ice buildup. This decision requires a professional assessment of the building and the installation. See the NREL guide to solar PV and storage systems.
If you contact a service provider, ask them to explain what need the work will address, how they will access the panels, and which manufacturer instructions they will follow. Do not scrape the glass, strike the ice, or apply hot water or chemicals. Also avoid repeatedly restarting the inverter without a technician’s instructions.
When to get in touch right away
Request an immediate assessment if, from a safe location, you notice a displaced panel, visible distortion, fallen components, or new water entering the building. If you are concerned about the roof, also notify the relevant engineer. If you see smoke, sparks, or another immediate hazard, move away and call emergency services.
Once the snow has cleared, check production during hours with available sunlight. If it remains unexpectedly low or errors continue, send the history to your installer. To compare readings, also read what the inverter and grid meter measure.
What to send your installer
- Address, date, and approximate duration of the snowfall.
- Photos taken from a safe location, with the time they were taken.
- Production screenshots from before, during, and after the panels were covered.
- Exact error code and the time the app was last updated.
- Description of any damage or water entering the building, without approaching the equipment.
If you are planning a new installation in an area with frequent snowfall, ask for the design to address snow loads, the array location, and protection for areas beneath the roof. Contact Solar Home to discuss your property details and design needs.